Wds Partner Mac (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

wds partner mac (access point)

With this command, you enter the MAC address of the WDS partner.

This command is available only in access point mode.

You are in the Interface Configuration mode for the WDS interface.

The command prompt is as follows:

cli (config-if-wdsX-0-Y)#

Call up the command with the following parameters:

wds partner mac <mac-address>

The parameter has the following meaning:

The MAC address is specified.

Further notes

You display the setting with the show wlan wds <wdsX 0/Y> command.

Table of Contents