Permit Icmp - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

src-ip-address

dest-ip-addres

For information on names of addresses and interfaces, refer to the section "Interface identifiers

and addresses (Page 29)".

The IP access list has been configured.

Subnet mask for individual hosts

If you create the rule for a single system (one IPv4 address), specify the subnet mask

"255.255.255.255". As an alternative, you can specify the keyword "host" followed by the IPv4

Further notes

You delete an IP access control list with the no ip access-list standard <acl-

num> command.

You display the configuration of the access control list with the show access-lists

permit icmp

With this command, you configure an IP access control list for ICMP frames.

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Source IP address

Network source address

Corresponding subnet mask

Blocks all outgoing frames

Keyword for a an individual IPv4 ad‐

Destination IPv4 address

Network destination address

Corresponding subnet mask

Keyword for the Differentiated Services

Value for the Differentiated Services Co‐

Security and authentication

11.5 IP access control list

Range of values / note

Enter a valid IP address.

Enter a valid combination of IPv4

address and subnet mask.

Enter a valid IPv4 address.

Enter a valid combination of IPv4

address and subnet mask.

Show Quick Links

Table of Contents