Wlan Security Ap-Radius-Authenticator Address - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Further notes

You disable the RADIUS server with the wlan security ap-radius-authenticator

You display the setting with the show wlan security ap-radius-authenticator

wlan security ap-radius-authenticator address

With this command, you configure the IP address of the RADIUS server.

This command is available only in access point mode.

You are in the WLAN Configuration mode of the WLAN interface.

The command prompt is as follows:

cli (config-wlan)#

Call up the command with the following parameters:

wlan security ap-radius-authenticator address <index (1-2)> {ipv4

<ucast_addr> | fqdn-name <FQDN(100) | ipv6 <ipv6-addr>}

The parameters have the following meaning:

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Index of the RADIUS server

Keyword for an IPv4 address

IPv4 address of the RADIUS server

Keyword for a domain name

Domain name (Fully Qualified Domain Name)

Keyword for an IPv6 address

IPv6 address of the RADIUS server

Security and authentication

Range of values / note

Enter a valid IPv4 address.

Maximum of 100 characters

Enter a valid IPv6 address.

Show Quick Links

Table of Contents