Table of Contents
Advertisement
Result
The settings for the active ports of the spanning tree function are displayed.
7.3.1.3
show spanning-tree bridge
Description
This command shows the settings of the spanning tree function of the bridge.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show spanning-tree bridge
[{address|forward-time|hello-time|id|max-age|protocol|priority|
detail}]
The parameters have the following meaning:
Parameter
address
forward-time
hello-time
id
max-age
protocol
priority
detail
Result
The settings for the spanning tree function of the bridge are displayed.
7.3.1.4
show spanning-tree detail
Description
This command shows the detailed settings of the spanning tree function.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Shows the MAC address of the bridge
Shows the time that the bridge is in the listening mode when changing from
the blocking mode to the learning mode
Shows the time after which the bridge sends configuration frames (BPDUs)
Shows the ID of the bridge
Shows the maximum age of the data packet after which it is deleted
Shows the protocol used
Shows the priority of the bridge
Shows detailed information about the spanning tree settings of the interface
Network structures
7.3 Spanning Tree
303
Hide quick links:
Advertisement
Table of Contents
