Commands In The Wlan Configuration Mode; Wlan Iprp - Siemens SCALANCE W770 Series Configuration Manuals

Functions specific to SCALANCE
5.7 iPRP
Result
The configuration is displayed.
5.7.2

Commands in the WLAN configuration mode

This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the wlan command to change to this mode.
Commands relating to other topics that can be called in the WLAN configuration mode can be
found in the relevant sections.
● If you exit the WLAN configuration mode with the exitcommand, you return to the Global
configuration mode.
● If you exit the WLAN Configuration mode with the end command, you return to the
Privileged EXEC mode.
5.7.2.1

wlan iprp

Description
With this command, you change to the WLAN iPRP Configuration mode.
Requirement
● The base bridge mode "802.1Q VLAN Bridge" is set.
● The VLAN is created.
● In client mode: for "MAC Mode", Layer 2 Tunnel is set.
● You are in the WLAN configuration mode.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call the command without parameter assignment:
wlan iprp
Result
The entry is has been created.
You are in the WLAN iPRP configuration mode. In this mode, you can configure the remaining
settings.
The command prompt is as follows:
cli (config-wlan-iprp-$)#
148
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08