Table of Contents
Advertisement
6.2.1
The "show" commands
This section describes commands with which you display various settings.
6.2.1.1
show ntp info
Description
This command shows the current settings for the Network Time Protocol (NTP).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ntp info
Result
The current NTP settings are displayed.
6.2.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
6.2.2.1
ntp
Description
With this command, you change to the Network Time Protocol (NTP).
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
System time
6.2 NTP client
173
Hide quick links:
Advertisement
Table of Contents
