Wlan Security Dot1X Eap-Authentication-Type (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Syntax
Call the command without parameter assignment:
no wlan security dot1x check-server-certificate
Result
Validation is disabled.
Further notes
You display the settings with the show wlan security command.
You enable the validation with the wlan security dot1x check-server-
certificate command.
See also
wlan security dot1x check-server-certificate (client) (Page 517)
11.3.4.6

wlan security dot1x eap-authentication-type (client)

Description
With this command, you specify which RADIUS authentication methods the client offers to the
RADIUS server. With "auto", the client offers a RADIUS server all supported methods. Any
other selection restricts the support by the client to this one method.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Syntax
Call up the command with the following parameters:
wlan security dot1x eap-authentication-type { show-types | <type> }
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Security and authentication
11.3 WLAN
519