Show Wlan Device - Siemens SCALANCE W770 Series Configuration Manuals

Network structures
7.1 WLAN
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan data rates <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The configured data transmission speeds for the corresponding WLAN interface are displayed
in the form of a table. The display of the tables depends on the selected frequency band and
the transmission standard.
7.1.1.12

show wlan device

Description
This command shows the WLAN basic configuration for the SCALANCE W700 device, for
example the mode (access point or client).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show wlan device
194
Description
WLAN interface
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
Enter a valid interface.
Configuration Manual, 09/2017, C79000-G8976-C324-08