No Ipv6 Address Link-Local - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.2 IPv6 protocol
The parameter has the following meaning:
Parameter
prefix
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Result
The link local address is assigned to the interface.
Further notes
You delete the link local address with the no ipv6 address link-local command.
You display this setting and other information with the show ipv6 interface command.
8.2.4.8

no ipv6 address link-local

Description
With this command, you delete the link local address.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ipv6 address <prefix> link-local
The parameter has the following meaning:
Parameter
prefix
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
376
Description
Link local address
Description
Link local address
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
Specify a valid link local address.
fe80::XXXX:XXXX:XXXX:XXXX
Range of values / note
Specify a valid link local address.
fe80::xxxx:xxxx:xxxx:xxxx
Configuration Manual, 09/2017, C79000-G8976-C324-08