Commands In The Loadsave Configuration Mode; Delete - Siemens SCALANCE W770 Series Configuration Manuals

4.2.5

Commands in the LOADSAVE configuration mode

This section describes commands that you can call up in the LOADSAVE configuration mode.
In the Global Configuration mode, enter the loadsave command to change to this mode.
You display the valid file types for the commands in the LOADSAVE Configuration mode with
the global command show loadsave tftp.
● If you exit the LOADSAVE configuration mode with the exitcommand, you return to the
Global Configuration mode.
● If you exit the LOADSAVE configuration mode with the end command, you return to the
Privileged EXEC mode.
4.2.5.1

delete

Description
With this command, you call up the possible files or delete a specific file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
delete{showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter
showfiles
filetype
filetype
Result
The files are displayed or the file is deleted.
Further notes
With the "show loadsave files" command, you can display the file types.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Shows the available files
Keyword for the file type to be deleted
Name of the file type
Configuration
4.2 Load and Save
Range of values / note
-
-
max. 100 characters
89