Configuration Save & Restore; The "Show" Commands; Show Running-Config - Siemens SCALANCE W770 Series Configuration Manuals

NOTICE
Loss of IP address / passwords with factory
By resetting all the settings to the factory settings, the IP address and the passwords are also
lost. Following this, the device can only be accessed via the serial interface using the Primary
Setup Tool or using DHCP.
With the appropriate connection, a previously correctly configured device can cause
circulating frames and therefore the failure of the data traffic.
Result
The device is restarted with the selected settings.
4.4 Configuration Save & Restore
This section describes commands for displaying, saving and restoring configuration settings.
4.4.1

The "show" commands

This section describes commands with which you display various settings.
4.4.1.1

show running-config

Description
This command shows configuration settings of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show running-config
[{
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
syslog|dhcp|stp|vlan<vlan-id(1-4094)>|
interface
Configuration
4.4 Configuration Save & Restore
101