Wlan Antenna Additional-Attenuation - Siemens SCALANCE W770 Series Configuration Manuals

Requirement
● The IEEE 802.11n transmission standard is enabled.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan amsdu packet-size <size (50-200)>
The parameter has the following meaning:
Parameter
size
Result
The size of the A-MSDU data packet is specified.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
7.1.5.12

wlan antenna additional-attenuation

Description
With this command, you specify the additional attenuation caused, for example by an additional
splitter. Using the show wlan basic command, check whether or not the current WLAN
settings violate the permitted transmit power restrictions (TX Power Check) of the selected
country.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna additional-attenuation <index (1-X)> <dB(0-70)>
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Maximum size of the A-MSDU data packet. 50...200 bytes
Network structures
7.1 WLAN
Values or range of values
Default: 100 bytes
219