Show Ipv6 Traffic - Siemens SCALANCE W770 Series Configuration Manuals

cli> or cli#
Syntax
Call the command without parameters:
show ipv6 static route
Result
The static routes are displayed.
8.2.2.5

show ipv6 traffic

Description
This command shows the statistics for UDP and ICMPv6 for the corresponding interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ipv6 traffic [
] [hc]
The parameters have the following meaning:
Parameter
interface
vlan
vlan-id
interface-
type
interface-
id
hc
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
interface { vlan <vlan-id> | <interface-type> <interface-id> }
Description
Keyword for the interface via which the statistics
are created.
● VLAN
● Interface
Keyword for a VLAN
Keyword for a VLAN connection
Type or speed of the interface
Module no. and port no. of the interface
Display of the High counters parameter
Network protocols
8.2 IPv6 protocol
Range of values / note
-
-
1 ... 4094
Enter a valid interface.
-
361