Snmp Group - Siemens SCALANCE W770 Series Configuration Manuals

8.6.2.12

snmp group

Description
With this command, you configure the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp group <GroupName> user <UserName> security-model {v1|v2c|v3}
The parameters have the following meaning:
Parameter
GroupName
user
UserName
security-model
Storage type
If optional parameters are not specified when configuring a group, the default values apply.
Result
The details of the group are configured.
Further notes
You delete the details of an SNMP group with the no snmp group command.
You display the created SNMP groups with the show snmp group command.
You display the created SNMP users with the show snmp user command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
[{volatile|nonvolatile}]
Description
Name of the group
Keyword for the user name
Name of the user
Specifies which security settings will be
used.
Specifies whether the settings remain
following a restart.
Network protocols
8.6 SNMP
Range of values / note
max. 32 characters
-
max. 32 characters
● v1
● v2c
● v3
● volatile :
The settings are lost after a
restart
● nonvolatile :
The settings are retained after
a restart.
423