End - Siemens SCALANCE W770 Series Configuration Manuals

Description
2.7 General CLI commands
The command prompt is displayed.
2.7.2 do
Description
With this command, you can execute the commands from the Privileged EXEC mode in any
configuration mode.
Syntax
Call up the command with the following parameters:
do [command ]
To do this, you replace [command ] with the command from the Privileged EXEC mode that
you want to execute.
Example
You are in the Interface configuration mode and you want to execute the write startup-
config command from the Privileged EXEC mode.
cli(config-if-$$)# do write startup-config
Result
The command from the Privileged EXEC mode will be executed.
2.7.3

end

Description
With this command, you exit the configuration mode and are then in the Privileged EXEC mode.
Requirement
You are in a configuration mode.
Syntax
Call the command without parameters:
end
38
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08