No Wlan Ipcf-Mc Roaming-Filter (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Functions specific to SCALANCE
5.6 iPCF-MC
Result
The number of measurements is specified.
Further notes
You display the setting with the show wlan ipcf-mc command.
You disable the setting with the no wlan ipcf-mc roaming-filter command.
5.6.2.7

no wlan ipcf-mc roaming-filter (client)

Note
The command is only available if the SCALANCE W700 device supports iPFC-MC or the
function can be enabled.
● iPCF-MC is enabled with the aid of the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5 907-8PA00)
– W740 iFeatures (MLFB 6GK5 907-4PA00)
Description
With this command, you disable the roaming filter.
Requirement
You are in the WLAN configuration mode.
The command prompt is as follows:
cli(config-wlan)#
Syntax
Call the command without parameter assignment:
no wlan ipcf-mc roaming-filter
Result
The roaming filter is disabled.
Further notes
You display the setting with the show wlan ipcf-mc command.
You enable the roaming filter with the wlan ipcf-mc roaming-filter command.
146
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08