Factoryclean; Firmware-On-Plug - Siemens SCALANCE W770 Series Configuration Manuals

In the Global Configuration mode, enter the plug command to change to this mode.
● If you exit the Plug Configuration mode with the exit command, you return to the Global
Configuration mode.
● If you exit the Plug Configuration mode with the end command, you return to the Privileged
EXEC mode.
5.1.3.1

factoryclean

Description
With this command, you delete the device configuration stored on the PLUG.
Requirement
● There is a device configuration on the PLUG.
● You are in the Plug Configuration mode.
The command prompt is:
cli(config-plug)#
Syntax
Call the command without parameters:
factoryclean
Result
The device configuration on the PLUG is deleted.
5.1.3.2

firmware-on-plug

Description
With this command, you specify that the firmware is stored on the PLUG.
Requirement
● There is a device configuration on the PLUG.
● You are in the Plug Configuration mode.
The command prompt is:
cli(config-plug)#
Syntax
Call the command without parameters:
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.1 PLUG
111