Option (Ip Address) - Siemens SCALANCE W770 Series Configuration Manuals

Result
The IPv4 address band is configured. The DHCP options 1, 3, 6, 66 and 67 are created
automatically. With the exception of option 1, the options can be deleted.
Note
DHCP options supported
The DHCP options 1, 2, 3. 4. 5, 6, 42, 66, 67 are supported.
Further notes
You display the setting with the show ip dhcp-server pools command.
You configure the DHCP options 1, 3, 4, 5, 6, 42 and 66 with the option (IP address)
command.
You configure the DHCP option 2 with the option value-hex command.
You configure the DHCP options 66 and 67 with the option value-string command.
You assign an IP address to an interface with the set interface command.
You delete the DHCP option with the no option command.
8.5.3.3

option (IP address)

Description
With this command you configure the DHCP options 3, 6 and 66 that contain an IPv4 address
as DHCP parameter. The DHCP options 3, 6 and 66 are created automatically when the IPv4
address band is created.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
option <option-code> { <ip-address-list> | int-ip }
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network protocols
8.5 DHCP server
397