Table of Contents
Advertisement
Network structures
7.1 WLAN
7.1.5.47
no wlan force roaming eth-down (access point)
Description
With this command, you disable roaming if the connection aborts on the Ethernet interface.
This setting is activated as default.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan force roaming eth-down
Result
The function is disabled.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
You enable the function with the wlan force roaming eth-down command.
7.1.5.48
wlan fragmentation threshold
Description
With this command, you specify the maximum packet size transferred on the wireless link.
Large packets are divided up into small packets prior to transmission and then reassembled
into the original size after they have been received.
250
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
