No Vap Communication With Own-Vap (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Security and authentication

no vap communication with own-vap (access point)

With this command, you specify that clients logged on to the same SSID of an access point

cannot communicate with each other.

This command is available only in access point mode.

You are in the Interface Configuration mode of the VAP interface.

The command prompt is as follows:

cli (config-if-vapX-0-Y)#

Call the command without parameter assignment:

no vap communication with own-vap

The communication option on the same SSID of an access point is disabled.

"within own VAP" function disabled

If the "within own VAP" function is disabled the various WLAN clients can no longer see each

other. This means that Address Collision Detection (ACD) also no longer works reliably.

Further notes

You display the settings with the show wlan security <vapX 0/Y> command.

You enable the function with the vap communication with own-vap command.

Table of Contents