Wlan Ampdu - Siemens SCALANCE W770 Series Configuration Manuals

Network structures
7.1 WLAN
Syntax
Call up the command with the following parameters:
wlan alternative channel { show-channels | <number (0=auto)> }
The parameters have the following meaning:
Parameters
show-channels
number
Result
The alternative channel is set.
Further notes
You display the setting with the show wlan basic <wlan 0/X> command.
You enable the DFS function with the wlan dfs command.
See also
wlan dfs (Page 240)
7.1.5.5

wlan ampdu

Description
With this command, you enable the sending of AMPDU data packets. The function is enabled
as default.
Requirement
● The IEEE 802.11n transmission standard is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan ampdu
214
Description
Lists all available channels.
Number of the alternative channel
If you want the access point to search
for a free channel itself, use "0".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
--
Default value: 0 (AUTO)
Configuration Manual, 09/2017, C79000-G8976-C324-08