Table of Contents
Advertisement
7.1.5.28
no wlan data rates-11abg selected only (access point)
Description
With this command, you enable / disable the automatic selection of the data transmission
speed.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● The transmission standard IEEE 802.11a/b/g/n is set.
Syntax
Call the command without parameter assignment:
no wlan data rates-11abg selected only
Result
The function is disabled. The data transmission speed is adapted automatically.
Further notes
You display the setting with the show wlan data rates command.
You enable the function with the wlan data rates-11abg selected only command.
You configure the transmission standard with the wlan mode command.
7.1.5.29
wlan data rates-11n selected only (access point)
Description
With this command, you enable the "Use selected data rates only" function. Only the data
transmission speeds you specified with the wlan data rate-11n command are used.
Note
This command is available only in access point mode.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.1 WLAN
233
Hide quick links:
Advertisement
Table of Contents
