Siemens SCALANCE W770 Series Configuration Manuals page 427

The parameters have the following meaning:
Parameter
TargetAddressName
param
ParamName
ipv4
IPAddress
fqdn-name
FQDN
ipv6
IP6-Address
timeout
Seconds
retries
RetryCount
taglist
TagIdentifier
none
volatile
nonvolatile
port
integer
For information on addresses and interfaces, refer to the section "Addresses and interface
names".
If optional parameters are not specified when configuring, the default values apply.
Result
The SNMP target address is configured.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
[timeout <Seconds(1-1500)] [retries <RetryCount(1-3)]
[taglist <TagIdentifier | none>] [{volatile | nonvolatile}]
[port <integer (1-65535)>]
Description
Name of the target address
Keyword for the parameter name
Name of the parameter
Keyword for an IPv4 address
IPv4 address of the trap recipient:
Keyword for a domain name
Domain name (Fully Qualified Do‐
main Name) of the trap recipient
Keyword for an IPv6 address
IPv6 address of the trap recipient
Keyword for the time the SNMP agent
waits for a response before it repeats
the inform request message
Time in seconds
Keyword for the maximum number of
attempts to obtain a response to an
inform request message
Number of attempts
Keyword for tag list
Tag identifier that selects the destina‐
tion address for SNMP.
No tag identifier
Specifies whether the settings re‐
main following a restart.
Keyword for the port number at which
the SNMP manager receives traps
and inform messages
Port number
Network protocols
Range of values / note
Maximum of 32 characters
-
Maximum of 32 characters
-
Enter a valid IPv4 unicast address.
-
Maximum of 100 characters
If you have stored a suitable domain
name, you can specify a host name.
-
Enter a valid IPv6 address.
-
1 ... 1500
-
1 ... 3
-
Specify the tag identifier.
-
● volatile:
The default settings are used
after a restart.
● nonvolatile:
The saved settings are used after
a restart.
-
1 ... 65535
8.6 SNMP
427