The "Show" Commands; Show Wlan Security - Siemens SCALANCE W770 Series Configuration Manuals

Some commands are available only in the "access point" or in the "client" mode. In these cases,
the titles have the term access point or client added to them.
Example: wlan mode
● wlan mode (access point): The function can only be used with access points.
● wlan mode (client): The function can only be used with clients.
11.3.1

The "show" commands

This section describes commands with which you display various settings.
11.3.1.1

show wlan security

Description
This command shows the security settings of the SCALANCE W700 device, for example the
encryption method.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan security <wlan 0/X | vapX 0/Y> [context <Id (1-8)>]
The parameters have the following meaning:
Parameter
wlan 0/X
vapX 0/Y
context
Id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
WLAN interface
Only available in client mode
VAP interface
Only available in Access Point mode
Keyword for a security context
Enter a valid security context ID.
Security and authentication
Range of values / note
Enter a valid interface.
Enter a valid interface.
-
Available only in client mode
1...8
11.3 WLAN
495