Wlan Overlap-Ap Aging (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Further notes
You display the setting with the show wlan basic <wlan 0/X> command.
You enable the outdoor mode with the wlan outdoor command.
See also
wlan outdoor (Page 259)
7.1.5.59

wlan overlap-ap aging (access point)

Description
With this command, you configure the aging time for the list of overlapping access points. If
an access point is inactive for longer than the set time, it is removed from the list.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan overlap-ap aging <min(1-7200)>
The parameter has the following meaning:
Parameters
min
Result
The aging time is specified.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Time in minutes (min)
Range of values / note
1...7200
Default: 120
Network structures
7.1 WLAN
261