Siemens SCALANCE W770 Series Configuration Manuals page 593

● Sending an e-mail
● Sending an SNMP trap
● Lighting up of the error LED
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
event config {cold-warmstart | linkchange | authentication-failure
| power-change | faultstate-change | stp-change | overlap-ap | wds |
dfs | wlan-general | ipcf-cycle-time | ipcf-poll-size |all}
{logtable | syslog | email | trap | faults | all}
The parameters have the following meaning:
Parameter
cold-warmstart
linkchange
authentication-failure
power-change
faultstate-change
stp-change
client-wlan-auth
overlap-ap
wds
dfs
wlan-general
ipcf-cycle-time
ipcf-poll-size
all
logtable
syslog
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Message if there is cold or warm restart
Message when there is a status change on a physical interface
Message if there is an incorrect login
Message when there is a status change in the power supply
Message when there is a status change in the error monitoring
Message when there are changes in the Spanning Tree
In client mode only:
Message for successful or failed WLAN authentication attempts (only in client mode)
Only in access point mode:
Message there is an entry in the "Overlap AP" list.
Only in access point mode:
Message when there is a change in the connection status of a WDS link
Only in access point mode:
Message when a radar signal was received or the DFS scan was started or stopped.
Only in access point mode:
Message when the channel bandwidth has changed.
Only available when the KEY-PLUG is inserted and only in Access Point mode
Message if too many clients are logged on for the set iPCF cycle time or if some clients
were not reached in one cycle
Only available when the KEY-PLUG is inserted.
Message when the PROFINET data size is too large for transfer.
All messages
Client that processes the logbook entries
Client that sends the messages to the log server
Diagnostics
12.1 Diagnostics
593