Static-Lease - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.5 DHCP server
8.5.3.10

static-lease

Description
With this command you specify that devices with a certain MAC address or client ID are
assigned to the preset IPv4 address.
Requirement
● The assignment has not yet been created.
● You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
static-lease {mac <mac-address> | client-id <string>} <ip-address>
The parameters have the following meaning:
Parameter
mac
mac-address
client-id
string
ip-address
Result
The assignment is specified.
Further notes
You display the setting with the show ip dhcp dhcp-server bindings command.
You disable the IPv4 address band with the no pool-enable command.
You delete the assignment with the no static-lease command.
404
Description
Keyword for a MAC address
Unicast MAC address
Keyword for a DHCP client ID
Freely definable DHCP client ID
Unicast IPv4 address
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
Specify the MAC address.
aa:bb:cc:dd:ee:ff
-
Enter the required designation.
Maximum of 254 characters
Enter a valid IPv4 address.
The IPv4 address must match
the subnet of the IPv4 address
band.
Configuration Manual, 09/2017, C79000-G8976-C324-08