Snmp View - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.6 SNMP
Further notes
You change the settings with the snmp user command.
You display the configured users with the show snmp usercommand.
8.6.2.24

snmp view

Description
With this command, you configure an SNMP view.
Requirement
● An SNMP group has been created
● The access to the group is configured with snmp access
● You are in the Global Configuration mode.
The command prompt is:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp view <ViewName> <OIDTree> [mask<OIDMask>] {included|excluded}
The parameters have the following meaning:
Parameter
ViewName
OIDTree
mask
OIDMask
View type
Storage type
If optional parameters are not specified when configuring, the default values apply.
434
[{volatile|nonvolatile}]
Description
Name of the SNMP view
Object ID
Keyword for the OID mask
Mask that filters access to the elements
of the MIB tree
Specifies whether the filtered elements
are used or excluded.
Specifies whether the settings remain
following a restart.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Range of values / note
max. 32 characters
Path information of the MIB tree
-
A series of "0" and "1" separated
by dots in keeping with the path in‐
formation of the MIB tree
● included (Default)
● excluded
● volatile:
The settings are lost after a
restart
● nonvolatile:
The settings are retained after
a restart (default).