No Spanning-Tree Mst Max-Hops; Spanning-Tree Priority - Siemens SCALANCE W770 Series Configuration Manuals

7.3.3.13

no spanning-tree mst max-hops

Description
With this command, you reset the maximum number of hops that a path in an MST can run
through to the default value.
The default value is 20.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree mst max-hops
Result
The setting for the maximum number of nodes is reset to the default value.
Further notes
You can configure the setting for the maximum number of nodes with the spanning-tree
mst max-hops command.
You display this setting and other information with the show spanning tree mst
configuration command.
7.3.3.14

spanning-tree priority

Description
With this command, you configure the priority of the device. Which device becomes the root
bridge is decided based on the priority. The bridge with the highest priority becomes the root
bridge. The lower the value, the higher the priority.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.3 Spanning Tree
319