Nat Interface (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Further notes
You show the NAT configuration and the translation list with the show nat command.
See also
show nat (Client) (Page 456)
10.1.3.6

nat interface (Client)

Note
This command is only available in the client mode.
Description
With this command, you enable NAT for the Ethernet interface.
Requirement
● You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
nat interface <interface-type><interface-id>}
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
NAT is activated for the Ethernet interface.
Further notes
You disable NAT with the no nat interface command.
You configure the MAC mode with the wlan client mac mode command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Type or speed of the interface
Module no. and port no. of the interface
Layer 3 functions
10.1 NAT
Range of values / note
Enter a valid interface.
463