Commands In The Global Configuration Mode; Ip Access-List - Siemens SCALANCE W770 Series Configuration Manuals

Syntax
Call up the command with the following parameters:
show interface access-lists [{<interface-type><interface-id>|vlan
<vlan-id(1-4094)>}]
The parameters have the following meaning:
Parameter
interface-type
interface-id
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available interfaces.
Result
The access control list of the selected IP interface is displayed.
11.5.2

Commands in the Global Configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
11.5.2.1

ip access-list

Description
With this command, you generate a MAC access control list and change to the ACL standard
configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a VLAN connection
Number of the VLAN
Security and authentication
11.5 IP access control list
Range of values / note
Enter a valid interface.
-
1 ... 4094
555