Nat Timeout (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Layer 3 functions

nat timeout (Client)

This command is only available in the client mode.

With this command, you configure the time period for the TCP / UDP connection. If no data

exchange takes place, the TCP / UDP connection is deleted from the translation table when

this time has elapsed.

You are now in the NAT Configuration mode.

The command prompt is as follows:

cli(config-nat)#

Call up the command with the following parameters:

nat {tcp|udp} timeout <seconds>

The parameters have the following meaning:

The period of time is configured.

Further notes

You show the NAT configuration and the translation list with the show nat command.

You delete the period of time with the no nat timeout command.

Table of Contents