Ipv6 Address Autoconfig - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.2 IPv6 protocol
Result
The IPv6 address has been deleted.
Further notes
You configure the IPv6 address with the ipv6 address command.
You display this setting and other information with the show ipv6 interface command.
8.2.4.3

ipv6 address autoconfig

Description
With this command you enable stateless autoconfiguration of the IPv6 address via NDP
(Neighbor Discovery Protocol).
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ipv6 address autoconfig
Result
Stateless autoconfiguration is enabled.
Further notes
You disable the setting with the no ipv6 address autoconfig command.
You show the setting with the show ipv6 dhcp interface command.
You can display the statistics of the DHCPv6 client with the show ipv6 dhcp client
statistics command.
372
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08