No Ports - Siemens SCALANCE W770 Series Configuration Manuals

Network structures
7.2 VLAN
7.2.4.4

no ports

Description
With this command, you reset the ports for a VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ports
The parameters have the following meaning:
Parameter
interface-type
/a-b,0/c,...
untagged
all
forbidden
name
vlan-name
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The ports are reset.
300
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
[
untagged ([<interface-type> <0/a-b,0/c,...>]
[<interface-type> <0/a-b,0/c,...>]
]
[
forbidden ([<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>]
]
[name <vlan-name>]
Description
Type or speed of the interface
Port no. of the interface
Keyword for interfaces or ports that transfer
data packets without VLAN marking
Specifies that all interfaces or ports are set to
"untagged"
Keyword for forbidden interfaces or ports
Keyword for the name assignment
Name of the VLAN
[all]
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
[all])
[all])
Range of values / note
Enter a valid interface.
-
-
-
-
max. 32 characters