Telnet-Server; No Telnet-Server - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.1 IPv4 protocol
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
8.1.2.1

telnet-server

Description
With this command, you enable the Telnet server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
telnet-server
As default the function is "enabled".
Result
The Telnet server is enabled.
Further notes
You disable the Telnet server with the no telnet-server command.
8.1.2.2

no telnet-server

Description
With this command, you disable the Telnet server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
346
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08