Commands In The Wlan Iprp Configuration Mode; Wlan Iprp Interface - Siemens SCALANCE W770 Series Configuration Manuals

Further notes
You exit the WLAN iPRP configuration mode with the end or exit command.
You display this setting and other information with the show wlan iprp command.
5.7.3

Commands in the WLAN iPRP configuration mode

This section describes commands that you can call up in the WLAN iPRP configuration mode.
In the WLAN configuration mode, enter the wlan iprp command to change to this mode.
Commands relating to other topics that can be called in the WLAN configuration mode can be
found in the relevant sections.
● If you exit the WLAN iPRP configuration mode with the exitcommand, you return to the
WLAN configuration mode.
● If you exit the WLAN iPRP configuration mode with the end command, you return to the
Privileged EXEC mode.
5.7.3.1

wlan iprp interface

Description
With this command, you configure the "iPRP" function. You specify the PRP network in which
the interface is a member. You can also enable the function for the required interface.
Requirement
● The interface is enabled.
● You are in the WLAN iPRP configuration mode.
The command prompt is as follows:
cli (config-wlan-iprp-$)#
Syntax
Call up the command with the following parameters:
wlan iprp interface <wlan 0/X | vap X 0/Y> network {A | B} {enable |
disable}
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.7 iPRP
149