Nat Local Ip Address (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Layer 3 functions
10.1 NAT
Further notes
You show the NAT configuration and the translation list with the show nat command.
You configure entries with the nat command.
See also
show nat (Client) (Page 456)
10.1.3.5

nat local ip address (Client)

Note
This command is only available in the client mode.
Description
With this command, you configure the IP address of the Ethernet interface. This IP address is
the gateway address of the local device.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
nat local ip address <ipaddress> {<subnet-mask>|/<prefix-
length(1-32)>
The parameters have the following meaning:
Parameters
ipaddress
subnet-
mask
prefix-
length
Result
The local IP address of the Ethernet interface is configured.
462
Description
Address of the Ethernet interface
Subnet mask of the local Ethernet
Decimal representation of the mask as a
number of "1" bits
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
specify a valid IP address.
enter a valid subnet mask.
1 ... 32
Configuration Manual, 09/2017, C79000-G8976-C324-08