Force Roaming Ip-Down (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Network structures
7.1 WLAN
Requirement
You are in the WLAN Configuration mode.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
country { show-countries | code <iso-code> }
The parameters have the following meaning:
Parameters
show-countries
iso-code
Result
The country is specified for the SCALANCE W700 device.
Further notes
You display the setting with the show wlan device command.
See also
show wlan device (Page 194)
7.1.4.5

force roaming ip-down (Access Point)

Description
With this command, you create a new entry in the table "Force Roaming on IP down" and
change to the force roaming configuration mode.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN configuration mode.
The command prompt is as follows:
208
Description
Shows a list of the countries that can be
set along with their two-digit ISO code.
Country code The country code com‐
plies with ISO 3166.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
--
Enter the ISO code of the required
country.
Configuration Manual, 09/2017, C79000-G8976-C324-08