Table of Contents
Advertisement
Network structures
7.1 WLAN
The parameters have the following meaning:
Parameter
index
dB
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Result
The additional attenuation is specified.
Further notes
You show the set value with the show wlan antennas <wlan 0/X> command.
7.1.5.13
wlan antenna cable-length
Description
With this command, you configure the cable length between the SCALANCE W700 device
and the external antenna.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna cable-length <index(1-2)> <m(0-30)>
The parameters have the following meaning:
Parameter
index
m
Result
The cable length is specified.
220
Description
Antenna connector
Attenuation in decibels [dB]
Description
Antenna connector
Cable length in meters [m]
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
X = 1
0...70
Default: 0
Range of values / note
1...2
0...30
Default: 0
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
