Nat Ipv4 Multicast Forward Local-To-Global (Client) - Siemens SCALANCE W770 Series Configuration Manuals

Layer 3 functions
10.1 NAT
Syntax
Call the command without parameters:
no nat ipv4 multicast forward global-to-local
Result
The forwarding of multicast frames is disabled.
Further notes
You enable the forwarding with the nat ipv4 multicast forward global-to-local
command.
10.1.3.10

nat ipv4 multicast forward local-to-global (Client)

Note
This command is only available in the client mode.
Description
With this command, you enable the forwarding of multicast frames. The multicast frames
incoming on the local Ethernet interface are forwarded via the WLAN interface into the external
network.
Requirement
● You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
● IPv6 is deactivated.
Syntax
Call the command without parameter assignment:
nat ipv4 multicast forward local-to-global
Result
The forwarding of multicast frames is enabled.
466
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08