Dest-Addr (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

Network structures
7.1 WLAN
In the WLAN configuration mode, enter the force roaming ip-down <index (1-10)>
command to change to this mode.
● If you exit the force roaming configuration mode with the exit command, you return to the
WLAN configuration mode.
● If you exit the force roaming configuration mode with the end command, you return to the
Privileged EXEC mode.
7.1.8.2

dest-addr (Access Point)

Description
Roaming depends on certain destination addresses. With this command you configure the
IPv4 address or the FQDN (Fully Qualified Domain Name) of the destination. To monitor the
device sends pings to the configured destination address at regular intervals.
Note
This command is available only in access point mode.
Requirement
You are in the force roaming configuration mode.
The command prompt is as follows:
cli (config-wlan-froid-$)#
Syntax
Call up the command with the following parameters:
dest-addr { ipv4 <ucast_addr> | fqdn-name <FQDN>}
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
274
Description
Keyword for an IPv4 address
Value for an IPv4 unicast address
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
Enter a valid IPv4 unicast address.
-
Maximum of 100 characters includ‐
ing 63 characters for domain name
(Domainname.com)
Configuration Manual, 09/2017, C79000-G8976-C324-08