No Nat Interface (Client); Nat Timeout (Client) - Siemens SCALANCE W760 Configuration Manual

Layer 3 functions
9.1 NAT
9.1.3.5

no nat interface (client)

Description
With this command, you disable NAT.
Note
This command is only available in the client mode
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call the command without parameters:
no nat interface
Result
NAT is disabled.
Further notes
You enable NAT with the
See also
show nat (client) (Page 349)
9.1.3.6

nat timeout (client)

Description
With this command, you configure the time period for the TCP / UDP connection. If no data
exchange takes place, the TCP / UDP connection is deleted from the translation table when
this time has elapsed.
Note
This command is only available in the client mode
356
command.
nat interface
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03