Chapter 9: Radar Commands; Mitigator Context - Siemens scalance WLC711 Reference Manual
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
9
Radar Commands
mitigator Context
Common Scan Group/Profile Commands
Note
Radar "In-Service Scan Profile" functions are currently not supported on SCALANCE WLC711
controllers. Any references in this chapter to In-Service scans do not apply until further notice. The
legacy Mitigator commands and functions related to "Out-of-service scan profiles" are available.
Radar provides: a radio frequency (RF) scanning task that runs on Wireless APs, an RF Data Collector
(RFDC) to receive and manage RF scan messages sent by Wireless APs, and an Analysis Engine to
process data from RFDCs generated by APs managed locally by the controller and also those from
other controllers. The Analysis Engine participates with Radar in generating historical reports and
reporting active threats. Radar reports threat events detected on AP36xx series and legacy APs in scan
groups to Wireless Manager as out-of-service scan profiles, and are handled as they always have been.
This chapter describes the commands that enable and configure the Radar options for the controller.
These commands are located in the mitigator context of the CLI.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
mitigator Context
The following commands are available at the highest (first) level of the mitigator context:
•
analysis
on page 175
•
wcswip
on page 176
•
scgroup
on page 177 — See
•
scprof
on page 181 — See
•
gsprof
on page 183 — See
•
maintenance
on page 184 — See
mitigator:maintenance context.
For In-service and Guardian scan profile configuration commands, see
Commands
on page 187.
analysis
Use the
analysis
it. The
analysis
SCALANCE WLC711 CLI Reference Guide
scgroup
on page 177 for commands in the mitigator:scgroup context.
scprof
on page 181 for commands in the mitigator:scprof context.
gsprof
on page 183 for commands in the mitigator:gsprof context.
maintenance
command to enable the Analysis Engine. Use the no form of the command to disable
command is accessible from the mitigator context of the CLI.
on page 184 for commands in the
Common Scan Group/Profile
175
Advertisement
Table of Contents
