Tamper-Evident Security Seals; Ingress Protection - Siemens SIMATIC NET RUGGEDCOM M969F Installation Manual

Rugged ethernet switches
Table of Contents

Advertisement

Cable Type
Wavelength (nm) Modal Bandwidth
a
OM4 (50/125)
a
Laser optimized.
1.6

Tamper-Evident Security Seals

In compliance with the security requirements of the Federal Information Processing
Standards (FIPS140-2), FIPS-compliant tamper-evident security seals are applied
to potential access points on this device. Security seals provide evidence of
unauthorized tampering or removal of components.
Worn, damaged or missing seals must be replaced immediately.
Replacement seals are available for purchase from Siemens. For more information,
contact a Siemens Sales representative.
There are three ways to determine if a security seal has been tampered with:
For information about the placement of security seals, refer to the
"RUGGEDCOM M969F FIPS 140-2 Non-Proprietary Security Policy [https://
support.industry.siemens.com/cs/ww/en/view/109757984]".
1.7

Ingress Protection

IEC International Standard 60529 (Edition 2.1: 2001-02) is a "classification of degrees
of protection provided by enclosures as a system for specifying the enclosures
of electrical equipment on the basis of the degree of protection provided by the
enclosure." These ratings are determined by specific tests.
The RUGGEDCOM M969F Industrial Ethernet Switch is manufactured and tested
to IP67 standards. With an IP67 rating a product will be "dust tight" and remain
completely sealed when immersed in water to a depth of 1 meter for 1 hour (IEC
60529).
These caps completely seal off unused ports on the IP67 Industrial Ethernet Switch. It
has an IP67 rated seal that keeps out all contaminants like dirt, oil, and water.
RUGGEDCOM M969F
Installation Manual, 11/2022, C79000-G8976-1349-04
(MHz·km)
1300
500
850
3500
1300
500
NOTICE
The seal is cut or torn
A pattern is left on the device when the top layer of the seal is removed
Residue left by the seal is visible on the device under ultra-violet light
1.6 Tamper-Evident Security Seals
Distance (m)
100Base-FX
1000Base-SX
2000
550
2000
Introduction
10GBase-SR
400
7

Advertisement

Table of Contents
loading

Table of Contents