No Mac-Address-Table Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.6 Multicast
Syntax
Call up the command with the following parameters:
mac-address-table static multicast <aa:aa:aa:aa:aa:aa> vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
-
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The settings for "static multicast" are configured.
Further notes
You disable the setting with the
8.6.2.3

no mac-address-table static multicast

Description
With this command, you delete a static multicast address.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
426
Description
MAC address of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
no mac-address static multicast
Range of values / note
aa:aa:aa:aa:aa:aa
-
1 ... 4094
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10