Sbus<N>:Uart:parity - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:SBUS<n>:UART:PARity
Command Syntax
:SBUS<n>:UART:PARity <parity>
<parity> ::= {EVEN | ODD | NONE}
The :SBUS<n>:UART:PARity command selects the parity to be used with
each message "byte" for the serial decoder and/or trigger when in UART
mode.
Query Syntax
:SBUS<n>:UART:PARity?
The :SBUS<n>:UART:PARity? query returns the current UART parity
setting.
Return Format
<parity><NL>
<parity> ::= {EVEN | ODD | NONE}
See Also
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 944
":SBUS<n>:UART:TRIGger:TYPE"
:SBUS<n> Commands
on page 935
on page 790
28
781