Sbus<N>:Spi:trigger:pattern:mosi:data - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA
Command Syntax
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA <string>
<string> ::= "nn...n" where n ::= {0 | 1 | X | $}
<string ::= "0xnn...n" where n ::= {0,..,9 | A,..,F | X | $}
The :SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA command defines the SPI
data pattern resource according to the string parameter. This pattern,
along with the data width, control the data pattern searched for in the
data stream.
If the string parameter starts with "0x", it is a hexadecimal string made up
of hexadecimal and X (don't care) characters; otherwise, it is a binary
string made up of 0, 1, and X (don't care) characters.
The :SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh should be set before
N O T E
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA.
Query Syntax
:SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA?
The :SBUS<n>:SPI:TRIGger:PATTern:MOSI:DATA? query returns the current
settings of the specified SPI data pattern resource in the binary string
format.
Return Format
<string><NL>
See Also •
•
•
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
(see page 790)
"Introduction to :TRIGger Commands"
":SBUS<n>:SPI:TRIGger:PATTern:MOSI:WIDTh"
":SBUS<n>:SPI:SOURce:MOSI"
on page 589
on page 506
on page 502
25
:SBUS<n> Commands
505