Acx4000 Network Cable And Transceiver Planning; Determining Transceiver Support And Specifications - Juniper ACX4000 Hardware Manual

ACX4000 Network Cable and Transceiver Planning

IN THIS SECTION

Determining Transceiver Support and Specifications | 82

Calculating Power Budget and Power Margin for Fiber-Optic Cables | 83
Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion | 85
Determining Transceiver Support and Specifications
You can find information about the pluggable transceivers supported on your Juniper Networks device
by using the Hardware Compatibility Tool. In addition to transceiver and connector type, the optical and
cable characteristics—where applicable—are documented for each transceiver. The Hardware
Compatibility Tool allows you to search by product, displaying all the transceivers supported on that
device, or category, displaying all the transceivers by interface speed or type. The Hardware
Compatibility Tool is located at
Some transceivers support additional monitoring using the operational mode CLI command show
interfaces diagnostics optics. Use the Hardware Compatibility Tool to determine if your transceiver
supports monitoring. See the Junos OS documentation for your device for a description of the
monitoring fields.
CAUTION: If you face a problem running a Juniper Networks device that uses a third-
party optic or cable, the Juniper Networks Technical Assistance Center (JTAC) can help
you diagnose the source of the problem. Your JTAC engineer might recommend that
you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.
SEE ALSO
show interfaces diagnostics optics (Gigabit Ethernet, 10-Gigabit Ethernet, 40-Gigabit Ethernet, 100-
Gigabit Ethernet, and Virtual Chassis Port)
show interfaces diagnostics optics (SONET)
show interfaces diagnostics optics
https:/ /apps.juniper.net/hct/.
82