Configuring Router Pe2 With A Remote Interface Switch - Juniper JUNOS OS 10.4 Manual

Router CE2
Configuration

Configuring Router PE2 with a Remote Interface Switch

Router CE1
Configuration
Copyright © 2012, Juniper Networks, Inc.
}
}
}
Configure the dual-tagged Ethernet interface.
[edit]
interfaces {
ge-0/0/0 {
flexible-vlan-tagging;
encapsulation flexible-ethernet-services;
unit 0 {
vlan-tags outer 100 inner 34;
family inet {
address
30.1.1.10/24;
}
}
}
}
You verify your configuration on the MX Series router with the
command:
user@PE2>show l2circuit connections
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid
MM -- mtu mismatch
EM -- encapsulation mismatch
CM -- control-word mismatch
VM -- vlan id mismatch
OL -- no outgoing label
NC -- intf encaps not CCC/TCC
BK -- Backup Connection
CB -- rcvd cell-bundle size bad
SP -- Static Pseudowire
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 10.255.171.45
Interface
ae0.0(vc 100)
Remote PE: 10.255.171.45, Negotiated control-word: Yes (Null)
Incoming label: 299872, Outgoing label: 299824
Local interface: ae0.0, Status: Up, Encapsulation:VLAN Q-in-Q and VCI
Interworking
The configuration of the remote interface switch is based on RSVP-signaled MPLS
connections.
Configure Ethernet over ATM on the ATM interface.
[edit]
interfaces {
Chapter 8: MX Series Router in an ATM Ethernet Interworking Function
NP -- interface h/w not present
Dn -- down
VC-Dn -- Virtual circuit Down
Up -- operational
CF -- Call admission control failure
IB -- TDM incompatible bitrate
TM -- TDM misconfiguration
ST -- Standby Connection
XX -- unknown
Type St Time last up
rmt Up May 12 14:48:58 2009
show l2circuit connections
# Up trans
2
85