Omron CS1W-MCH71 Operation Manual page 541

Interface Specifics
Error amount
In-position range
Axis Control Bit:
Error Counter Reset
Axis Status Bit:
Busy
Axis Status Bit:
Axis Operating
Axis Status Bit:
Positioning Completed
496
Basic operation 2 (The bit [Error Counter Reset] is turned OFF without check-
ing the bit [Positioning Completed].):
0
1
0
1
0
1
0
1
0
The bit [Axis Operating] is OFF. Therefore, the error
counter reset processing is immediately started.
Because the bit [Error Counter Reset] is turned
OFF, processing will be interrupted and the bit
[Positioning Completed] will not turn ON.
When the bit [Error Counter Reset] is turned
OFF, the bit [Busy] will turn OFF.
T1
Section 7-4
Time